2007 toyota tundra 4×4 looking for good brake pads?

Wagner Brake Pads 2 Comments »

i’m looking at WAGNER and POLY QUIET an suggestions and wanna be under 120 bucks if possible

try bendix Ceramic BrakBrake Pads, they work great and are cheap.

wagner thermoquiet brake pads…..!!!!!?

Wagner Brake Pads 4 Comments »

recently replaced all for pads to these wagner pads and replaced front rotors only…
brakes seem to be squealing once i depress the brake pedal for a quick 5 seconds but stops as i come to a stop.
they dont seem to squeal in the rain.
no lube or shims came with these pads and not sure why the are squealing.
easy installation but cant figure out why there is noise. put about 1k miles on the new pads.
never had this problem before.

thnx for your help

if you did not clean the new rotors with breakclean before you installed them then there is still going to be a layer of anti-rust sealant on the rotors that make the brakes crystallize and then make the squealing sound. however those brakes come with an anti-squeal warranty, i’d take them back off and back to the store where you got them and get a new set. just tell them that they are squealing and the whole reason you opted for the higher price was to not have the squealing sound when you applied the brakes. then buy yourself a can of breakclean to go with it and it should solve your problem.

Anything special (tool) needed for 03 odyssey brake replacement?

Wagner Brake Pads 1 Comment »

Hi all,
I am getting read to change my rear Brake Pads with brand new Wagner Thermo Quiet Pads that I got a few months ago. I changed the front pads a few years ago and had no issues with it, and in order to pass the state inspection the rear ones will have to be changed. So I was wondering if I needed anything special other then what you normally need to change the pads (pads, clamp, etc etc) because I remember about 5 years ago I needed something specific to Honda to change the rear brakes on my 99 accord. So, if someone could let me know if I need anything special that would be great!
@ Delmer How much is it and from where? Why didn’t I need it for the front

yes there is a Special tool needed the pistons have to be screwed back into the calipers .

Previous Entries

Why we do a good brake job