After replacing the rear pads and rotors, the wheel won't turn. The parkig brake is too tight.
One answer came close, the brakes are self adjusting. However, during my installation, I failed to screw in the caliper piston and position it correctly. It is supposed to be orientated in a manner that allows the pin on the pad to be in the allotted recess on the piston face. I found this in a chiltons manual.

if you did it right you should have noting to adjust it is self adjusting. As son as you pump the brake pedal a few times the brakes should be ready to go.

How do you release the pressure in the brake lines for changing brake pads?